You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The first post

Monday, January 15th 2018, 12:44am

by PerryNZ

Quasi Drain Valve

I have a zone that is all above-ground PGPs. Accordingly, I need to drain it to stop winter frost damage. The lowest part of the zone is a Hunter valve, in a box. The valve is isolated from the mains by a ball valve. (It's an Irritrol controlled solenoid valve)

My question is - rather than install a special drain point - can I close the isolating valve and remove the solenoid and thereby drain the zone? I.e. Will water lying in the sprinklers and pipes drain slowly back through the now-open valve's solenoid orifice?

Been a while since I posted. Hello to wet boots et al. :thumbup: