You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4364 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Thursday, June 8th 2006, 3:46pm

by Wet_Boots

Use the MV terminal - Master Valve is the same as Pump

Thursday, June 8th 2006, 1:47pm


hunter-no pump connection

I am replacing my old controller that went bad. It was a Richdel model 508PR. It had a pump wire along with the zone and common wires, I bought a Hunter SRC Plus. I notice it has no pump connection but the manual says you can purchase a seperate pump start relay. Do I need to buy one of these or is there a connection on the controller for this wire? I did not realize I even had a pump on this system. The manual is a little unclear.