You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3083 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Friday, April 7th 2006, 4:01pm

by wetyet

Thank you sir for the response. I'm not familiar with much of the golf course type pump systems technology.. I get conflicting answers from my suppliers and nothing concrete. Have a good friend that worked on irrigation on golf courses for many years and I will call him tonight. Sounds like it might be as cost effective to pull the wire I need. It's a ****uva distance. I just need to put real options into the hands of the homeowner.

Thanks again for your response.


Friday, April 7th 2006, 2:26am

by Wet_Boots

I think (actually, I <u>know</u> it, but don't know the specific equipment sold for it) it's possible to 'multiplex' several valves through that extra pair of wires, so you'd be able to use the original controller. More of a golf course thing than the residential work I do.

Thursday, April 6th 2006, 4:16pm

by wetyet

Adding a 2nd controller to a pump system

The setup is this, The pump, pump start relay, and existing controller are all next to the water source, a pond. It is a 10 acre piece of land that has all been irrigated except for behind the homeowners house. App. 4 rotor zones and a drip zone are needed.
The house and the pond are on opposite ends of the property, quite a distance. I can get the water I need from the closest valve manifold located in the front yard of the house. Whoever installed it ran 2 ea. 13 strand, 18 guage multi-strand and I have access to two spare wires in that manifold as well.

I was wondering if I could use one of those spares for the pump relay and mount a second controller on the house to accomodate the additional valves i need to install. Will power run back through the existing wire hooked to the relay and possibly back into the controller at the pond. The alternative is to use the existing controller (there are 6 open terminals) and pull wire a very long distance.I'm just concerned of the possibility that I may fry that expensive controller. Wanna do the right thing.
Thanks in advance for any thoughts. Hope I worded it so the question is understandable.