You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4613 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Wednesday, November 2nd 2005, 10:20am

by HooKooDooKu

If I understand what you are trying to do, you are converting an irrigation circuit (likely using 3/4" to 1" pipe) to drip irrigation, and you're doing this in what you call "not a really bid yard".

Well if the pipe in the ground is only 3/4" and the total output of the circuit stays below 300pgh, then a 200' run of pipe would have at most about 4psi pressure difference.

So if I'm understanding right, I don't see what's the point of more pipe in the ground. The bigger issue is to ensure you don't have too much pressure comming out of the irrigation system. While I think most drip systems indicate they will handle upto 50psi, I think you really want the system to be closer to 25psi.

I've never used them, but I read that Rainbird (perhaps others) have conversion kits. These kits replace a spray head and include a pressure regulator, filter, and something to tie your drip tubing into. If you used these kits at each spot you want to tie into the circuit, the pressure inside the pipe would stay high all around the yard AND you'd get that 25psi lower pressure desired by the drip irrigation.

Saturday, October 29th 2005, 5:52pm

by Tom

by looping a line you effectively cut your pressure loss by half.

Saturday, October 29th 2005, 9:24am

by malibu jim

What is the result of looping? Does it help equalize the pressure?

Saturday, October 29th 2005, 1:51am

by Wet_Boots

No problems with looping the line. It's more commonly a technique employed in large systems where they loop a main line that individual zones tap from.

Friday, October 28th 2005, 5:02pm

by malibu jim

Closed Circuit

I am redoing a line in our back yard that runs thru perimeter flower beds and removing a few spray heads to install quite a few Rain Drip hydro ports for a drip system. Since this system encircles most of our yard (not a real big yard) I was worried about loosing pressure at the end of the run and wondered what would happen if I T'd the line out of the valve and made a complete loop around the yard, Would this help at all, even though the supply is goverened by the flow through the valve? I've never heard of doing this, but it sounds like it might help to equalize the pressure.