You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3434 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Saturday, July 2nd 2005, 5:38pm

by tozar

Thanks for the help.

I'll use the 1" poly X 1/2 FPT and 1" poly X 3/4 FTP combination "T" and ells to MPT funny pipe straight and ells.

I didn't see the 1" x 3/8" insert couplings and "T"s.

It's alot easier if I can see all the parts in front of me. Going back and forth with web pages is a pain trying to see what fits together and what doesn't.

Friday, July 1st 2005, 9:25pm

by Wet_Boots

Two ways exist to get from the one inch poly to the sprinkler heads using funny pipe (often designated with a 3/8" size on the insert fittings) - You use 1" x 3/8" insert couplings or tees, or use 1" insert by female pipe thread tees or ells, and thread a funny pipe elbow into the female threaded insert fitting.

Friday, July 1st 2005, 3:43pm

by tozar

Poly fittings to sprinklers?

I'm in the process of putting together a materials list for a sprinkler system on this site. I've found just about everything I need.

I would like to connect poly from the valves to the sprinkler heads using 1 inch poly. The sprinkler heads have 3/4 or 1/2 FPT and I need 1 inch poly to MPT for these sizes. I see the swing pipe fittings, but the size is not listed for the poly connection. It just says 1/2 MPT - no 1/2 MPT & 1 inch poly for the specs.

Am I missing something or is it assumed to be 1 inch poly?

Also, the poly (funny pipe) 100ft rolls, is this 1 inch 100 psi?

I would like to go 1 inch from the valves all the way to the sprinklers.

Thanks!