You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4760 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, June 12th 2005, 6:53pm

by RidgeRun05

If your contractor is installing funny pipe for your main lateral lines for your sprinklers, you need to stop work ASAP and go over the entire installation. Better check the plumbing from your POC (Point of Connection) all the way out. Like Wetboots said, I hope there is a backflow device installed. For the pressure, I would be installing at least 1" line for your sprinklers. You can come off of that line with your funny pipe to your sprinkler heads, but DO NOT use funny pipe for the entire system. Time to have a sit down with your contractor.

Sunday, June 12th 2005, 12:00pm

by Wet_Boots

Stop the installation work. Nothing smaller than 3/4" pipe should be used with rotor heads. Funny pipe is okay to connect a head to the regular pipe, but no more. (In certain circumstances, mostly retrofit work, funny pipe might feed more than one small capacity head [but not multiple rotors]) - What state is this work taking place in? I hope there is backflow prevention in place.

Sunday, June 12th 2005, 7:48am

by aseidman

Frustrated.. Help !

OK.. My property is 40 by 100. The house is 50x25.

We have 50 -60 PSI of water pressure and a 4 zone unit.

In theback yard, we do not seem to be getting full coverage. Not sure why... the thrid head on the line seems to have under 10 PSI by the time water gets to it.

The system he is installing is a Toro System. He is using funny pipe for the entire system. I read that Toro suggests you only use funny pipe within 4 ft of the spray heads. The local supply house told my installer that he could use it for the entire system. Could this be causing the problem ??? I the funny pipe diameter and the joints and issue for flow ?

HELP ! I am getting nervous now....