You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4087 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Friday, May 16th 2003, 2:20pm

by Rays Sprinklers

If its leaking you probably need more teflon,i would wait unless you want to do it now, cut the pvc install slip couplings and unions



Thanks
Ray
Rays Above and Beyond Automatic Lawn Sprinklers

Monday, May 13th 2002, 3:53am

by RVLI

From what I understand, the dripping is really slow. Let it go until winterization or spring start to fix it. When you do, switch to unions like you said. Don't forget to put 2-3 wraps of teflon tape when you fix it.


Monday, May 6th 2002, 5:56am

by daronson

Backflow leaking at inlet & outlet fittings

Recently installed a 10 zone system with 2 manifolds, each with it's own PVB. PVB's have female threads, so I threaded in a male PVC connector (with teflon tape) and glued the pvc to this.

The threaded pvc connection to the pbv has a slow drip, both inlet and outlet. I hand tightened and gave some exta torque with a pipe wrench. I did not use unions, so the only way to get the pvb off is to cut it off and re-do the pbv connections, and switch to threaded unions.

Is there a "quick fix" solution that will seal up this drip (assuming I drain the pipe and relieve the pressure), or should I not worry about it since it is outside and only a small drip, or does it need to be cut off and fixed correctly? If the latter, can it wait until fall when I winterize?