You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2383 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, March 11th 2008, 2:57pm

by HooKooDooKu

Because you are talking about a spot protected from the sun, it would likely be ok to use PVC after the valves for for the trip back down to the ground. I've seen several pictures online of installs done that way. I know it's against general practice (and codes in some areas) to have PVC above ground for the mainline, but from you you are discribing, you only want to possibly use PVC for the lateral lines (the lines AFTER the valves).

But from the point of view of protection (kids playing, weed-eater, rocks kicked by lawn mower) I feel like it would be safer all around to use copper going back down to the ground. Once underground, you could then use a copper FEMALE to transition to a male PVC or male poly addapter. Notice the specification of FEMALE on the metal side. When you go to screw the metal-to-plastic transision pieces together, you do not want the plastic part to be the female side. The reason is because the metal basically is NOT going to give any in a contest between plasic and metal. The plasic will hold much better being compressed by the metal female. If you tighten female plastic over male metal, you are very likely going to crack the plastic.

Thursday, March 6th 2008, 2:04pm

by asrichardson

Above-ground pipes

My new sprinkler installation layout works best with the main and several zone valves mounted above ground on the outside of a basement wall, in a shady location. I have 1" copper coming to the main valve and will be using 1" and 3/4" poly for the underground runs. What should I use for the above ground pipes from the valves to the underground poly? I am worried about UV degradation over time if I use PVC -- do I need copper or some other durable pipe, or will poly be OK? The out-of-the-ground run is about 8ft. Thanks for any advice to a newcomer to this game.