You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2490 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Saturday, September 29th 2007, 9:31am

by Admin

Sounds like you have a bad valve Soleniod or Diaphram.

Here is what I suggest you do if you have a bad solenoid or Diaphram.

<b>Replace the Solenoid and Diaphram at the same time</b>
I recommend replacing the entire valve top and internals instead of just the solenoid. If the solenoid is bad the diaphram is more than likely not going to last to much longer and you will find yourself digging the valve up again in the near future. Besides, a complete new valve is almost the same price as a new solenoid and you can use the new valve to get all your new parts very easily.

<b>How to do it</b>
The best way I have found to remove the mud and dirt is to dig up the valve box and use a hand trowel or your hands to dig the mud and dirt from around the valve(s). This will also give you a lot of room to work on the valve.

Use plenty of paper towels to wipe the dirt away from the valve top and side to allow you to replace the valve top and internals by unscrewing the screws or unscrew the valve screw on top if it has a screw top. You would need to replace the valve top and internals with the exact same model of the older valve you are replacing. Otherwise you would need to cut out the valve and replace it with any brand and any model valve as long as it fits on the same pipe size.

You just unscrew the top of the valve off the new valve and use it (which has a new soleniod on it) and the diaphram and spring inside the new valve to replace the old parts on the old valve. Once you open a new valve and see how simple it is inside, you should feel comfortable doing this. It is soooooo easy!!!!!


I hope this helps.

Sunday, September 16th 2007, 7:17am

by mrfixit

Are you saying the valve is on 24 hours a day? Cutting the wires alone wont cause that. There's a problem with the valve.

Sunday, September 16th 2007, 4:31am

by TJ

zone won't shut off

System is weathermatic vave and controller 9 zones. Recently cut by contractor. Spliced together 13 lead wire but, one zone always comes on power or no power any thoughts?