You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2691 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, August 7th 2007, 2:46pm

by jmduke7

Be careful though. This problem has been known to disappear and then reappear at random. If I remember correctly, the problem lies in the ribbon cable that connects the faceplate to the rear panel. Just keep your eyes on it for the next few days. Only time will tell!

Tuesday, August 7th 2007, 2:39pm

by TexDude

OK, I unhooked the wire on the MV terminal and reset the controller and ran through all 6 stations using the manual start advance and did not get the error. So it looks like I'll have to replace this relay or solenoid.

Now I just have to find it....

And the parts.

Tuesday, August 7th 2007, 2:30pm

by jmduke7

OK, where to begin. First thing first. You may have a controller that has some "issues". There have been some instances throughout the US with this exact problem and there is either no MV hooked to the controller (master valve or pump start relay) and it shows this error, or there is a legitimate problem with your master valve. First, look to see if you have a wire, or wires, hooked to the MV circuit. If so, disconnect it and restart the controller. If the problem goes away, you have a bad solenoid, or pump start relay .If you do not have a wire, or wires, hooked to the MV circuit, you will need to take the WHOLE controller down (not just the faceplate) and swap it for a newer one (no worries it's under warranty) preferably with one that has a date code of around mid July or later.

Tuesday, August 7th 2007, 2:19pm

by TexDude

Rainbird ESP-M "MV ERR"

Can anyone tell me what this means? I am getting this error when I try to run my system (Rainbird ESP-M). I would like to try and fix it myself if possible as I have gotten killed so far this year with repair bills on the sprinkler system at my home.

I found a couple of sites that talk about a main valve where the system hooks into the water main so I'm thinking that's what "MV" means.

I'm going to try and see if I can figure out where this valve is but, I'm not sure how to test to find out if it's the wiring or the valve. I'm also not sure if this possibly being a main valve, if this is something I should attempt on my own.

Any feedback would be appreciated.

Thanks.