You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2459 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, July 31st 2007, 3:25am

by wiredup

Ahh, you found them! Thank you.

Tuesday, July 31st 2007, 2:57am

by worachj

Need to know which rotor you have. Here are instructions for Nelson rotors.

Gear drive:
http://www.nelsonturf.com/products/instructions.cfm?CAT=GEAR%20DRIVES

Impact rotor:
http://www.nelsonturf.com/products/instructions.cfm?CAT=OTHER%20PRODUCTS



Tuesday, July 31st 2007, 1:36am

by wiredup

How to configure Nelson rotor / initial install?

Hi team,

I purchased Nelson rotors and am not sure how to setup the direction correctly. I know that the top of the head has adjustments for degrees in the arc, however how do I determine the "stop" position...?

For example, the rotor turns from 1 to 360 degrees alternating back and forth (not a continuous circle). How do I find the "stop" and correlate it to the edge of my lawn so that I can "add" the appropriate degrees for coverage?

(I hope all of that makes sense)

Jason