You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2749 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, June 12th 2007, 5:53am

by HooKooDooKu

The one thing to NOT do is space the other heads further away. The issue with heads on slopes is that a head that is shooting uphill will not throw water as far as one shooting down hill. So if anything, you will want the other heads spaced closer to the down hill rotor to compensate for its limited range.

The reasons for angling a head to compensate for slope is so that the water spray into the hill side doesn't start erroding the hill. But with the hill being such a short distance from the head, the bulk of the water will be shoot past the point of the top of the hill.

So my first thoughts are:
1) Ignore the difference
2) Compensate for the difference by moving other head closer to the corner (by maybe 6"), or
3) use the 12" pop-ups so that half of what should already be a minor difference is compensated for.

Now since I'm making suggestions only based on educated guesses. You could just do some practical tests to see how much of a difference it's really making. Rig up a sample head so that you can power it from a garden hose (may big box stores will have hose to pipe thread converters). Turn the hose on and hold the head near the ground at the bottom of the slope and note how far the water is being thrown. Now go to the uphill side at the far point the head was tossing water. How much of an over shoot does the head have going shooting downhill. That will show you how much to change the spacing.


Monday, June 11th 2007, 4:57pm

by schulz80134

Sharp slope in corner of yard

Hi! I could really use some help with designing rotors around a slope in the corner my yard. (FWIW, I'm following the info at irrigationtutorials.com)

I'm using rotors for the main rectangular part of my yard (with some spray heads covering the non-rectangular area). As the rotors are covering a rectangle they've been reasonably easy to design. The problem that I'm running into is that one corner of the rectangle has a sharp slope to the corner. It drops around 12-18" over the final five feet to the corner.

I don't know whether I should
1) Angle the rotor head in the corner to compensate for the slope
2) Get a 12" head instead of a shorter head
3) Space the other heads further away
4) All of the above

Any help would be appreciated!