You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4026 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Tuesday, June 12th 2007, 6:13am

by Wet_Boots

Try to get by without the booster. Consider using Hunter PGP heads, with their smaller nozzles, which make them far better than the I-20 head for small water supplies.

Tuesday, June 12th 2007, 2:23am

by EvilSergeant

I was thinking that this pump might be good.

I have city water and I have recently installed a new 1" line from the main. When my sprinkler system is on I loose alot of pressure in the house. If I install the above pump from the main I could stop all this.

Would this pump creat jerky water performance?
What could I do to even it out?

Tuesday, June 12th 2007, 2:07am

by EvilSergeant

I have 1 gpm nozzles and 4 heads per zone.. I do think that my valves have a little leak by. The system is 6 months old.

What do you think about a boster pump?

Monday, June 11th 2007, 5:04pm

by Wet_Boots

Buy new heads, or maybe try smaller nozzles in the existing ones.

Do make certain that there aren't any partially-closed valves in the circuit, if what you are seeing is a overall lack of performance.

Friday, June 8th 2007, 4:57pm

by EvilSergeant

Weathermatic Turbo 3 will not pop up

My sprinkler system with Weathermatic Turbo 3's will not pop up everytime. The times they do not pop up, I must go out, pull up one head and push it down and then they all pop up and work fine and the seal leaks stop. When the system starts working the spray is very strong. When it is not working, they all look like water is blowing by the seal.

I have done two things if fix it. Cut the springs on a few heads on one zone. Installed I-20's for a few heads on another.

I like the Turbo 3 better than the I20 because they are much easier to adjust.

What can I do to fix the Turbo 3's?
Has anyone else had problems with Turbo 3's?
What head should I buy if I have pop up problems?

Any help is apprecated.