You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4030 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 7 posts

Friday, June 8th 2007, 6:22pm

by Wet_Boots

One useful tool for dealing with the marginal and intermittent electrical faults is a clamp-around ammeter. Only a very few models were useful at solenoid-level currents, though. Probably something that a modern digital version could deal with.

Before the advent of error codes on solid-state controllers, it sometimes took a current reading to catch a flawed solenoid.

Friday, June 8th 2007, 3:18pm

by 22sprinklerman

thank you very much. That answer was what i was looking for.

Thursday, June 7th 2007, 4:35pm

by Wet_Boots

You may have a marginal solenoid, drawing too much current, or maybe a slight short circuit. Take electrical measurements.

Thursday, June 7th 2007, 3:44pm

by 22sprinklerman

I read the manual and i counldnt find an answer that i was satisfied with thus my simple question

Thursday, June 7th 2007, 12:05pm

by Wet_Boots

What were the results of your measurements of solenoid resistance and/or current draw for the zone in question?

Thursday, June 7th 2007, 4:06am

by Wet_Boots

Download a manual from Weathermatic and read it.

Wednesday, June 6th 2007, 6:15pm

by 22sprinklerman

Err Zone 3

I recently came across a WM Weathermate 12 zone ID Control (weathermatic) control with Err Zone 3 on the screen only that the zone was working ok. Does any one know why that is? zone turns on and shuts off properly.