You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2696 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, May 15th 2007, 4:29pm

by ajle1

Thanks, I will give it a shot...would I have to special order these valves or do the big hardware stores normally keep them stocked?

Sunday, May 13th 2007, 3:21am

by jmduke7

Are the other three heads on the same lateral line? When your head was damaged / broken, dirt and debris may have gotten in the line. You may want to remove the nozzles of those spray bodies and flush any sand or debris out by turning on the valve. BUt this will only be evident if the other heads on the same zone are working. If there is no water what so ever, then a valve replacement as Boots suggested is your wisest choice.

Saturday, May 12th 2007, 9:28am

by Wet_Boots

Buy a new valve of the same make and model of the existing non-working valve, and swap out all the parts.

Saturday, May 12th 2007, 8:49am

by ajle1

Problem with zones

I recently had a broken pop-up sprinkler head...water was flowing through this terminating head and four others in this zone (1). I replaced the head, no apparent cracks in the piping. When I turned the zone on, very little water was leaking out and no water coming out the other three heads in that zone.
A total of six zones...all worked but zone (1) and the adjacent zone...total of four still working.

Not sure how to trouble shoot...found the solenoid/valves... 2 X Richdel 205s...don't know if they are working or not.

Can you advise likely problem or how to trouble shoot?