You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4248 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, April 24th 2007, 8:55am

by SprinklerGuy

Hi...thanks for posting....

It is quite simple really and like anything else, most of us have our own technique. Here is how I do it:

go outside to backflow preventer and turn the incoming valve to the off position (this is the valve at the bottom of the backflow on most backflows...or the valve closest to the pipe coming out of the house)

Make sure any drain caps....on the elbow or somewhere on the pipe coming out of house....are in the closed position as well.

Go to basement/crawlspace/waterheater closet or wherever the water tap is....turn that drain off and open the water valve slowly....allowing the water to fill the pipe to the outside.

Go outside and ensure that all drains in all valve boxes are in the closed position and all bleed screws etc on all valves are closed.....and / or solenoids are closed/ turned to off position.

Make sure test cocks....are in closed postition and open water valve at bottom of breaker that you had shut earlier.....allowing water to fill the system.

Check valve boxes for leaks, check backflow for leaks....turn each zone on with timer and check each head for proper adjustment and/or leaks.

Anything that has happened over the winter should show itself if it is bad....otherwise you should be good to go.

Good luck!

Monday, April 23rd 2007, 5:22am

by sudhirjain

Starting the Sprinkler System during Spring

Is somebody have the procedure "how to start the the Sprinkle system during Spring/Summer for the first time after Winetrization". Please suggest.