You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4321 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Wednesday, March 21st 2007, 8:10am

by Wet_Boots

If your well point is a two-inch pipe, then you have the possibility of using a deep-well pump and ejector assembly. This is expensive, but less expensive than an artesian well and submersible pump. The deep-well jet pump will push some water back down the well, through an injector assembly. The assembly, in combination with its gaskets, and the inch-and-a-quarter pipe connected to it, lets you pump water from a deeper well. One possible problem here is that there isn't a whole lot of difference between the 28-foot water level and the 35-foot well bottom$department/deptdocs.nsf/all/agdex639?opendocument

Wednesday, March 21st 2007, 6:33am

by shmoe

<blockquote id="quote"><font size="1" face="Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote"><i>Originally posted by Wet_Boots</i>
<br />What is your well point diameter? There are steps you can take short of the expense of a deep well.
<hr height="1" noshade id="quote"></blockquote id="quote"></font id="quote">
2" inlet,1.5" outlet 2hp pump. The sand point is 35' deep.

Wednesday, March 21st 2007, 6:23am

by Wet_Boots

What is your well point diameter? There are steps you can take short of the expense of a deep well.

Wednesday, March 21st 2007, 5:12am

by shmoe

Shallow Well

Is there any thing I can do. My water table has dropped to 28'. My pump sits about 4' higher than my neighbors due to house built up a bit higher. In the last 3 years, my pump doesnt push water like it used to. Local well co. said I might need to go deep well. I put in a new point last year but to no avail. Is there any thing I can do or is there a pump that will pull more than 25'? Deep well is expensive.
Thank you