You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4054 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, March 19th 2007, 9:21am

by Wet_Boots

figure on replacing the diaphragm assembly

Monday, March 19th 2007, 8:17am

by srgipson

Low Volume Valve

I have a 6 station system and 5 of the stations work fine. One valve opens and closes, but allows only a limited amount of water pressure through. The valves are all Richdel 713APR's. If I lossen the black pressure releif screw I get full pressure, but I think that this just bypasses the valve (not sure how it really works). I looked for potential replacement parts for the valve since I can see it would be a bear to replace. I began with replacing the solenoid (because it was the easiest). The only other replcement part I found was a diaphram (which I have not yet replaced). Am I even on the right track to resolving this pressure issue? Any help would be appreciated.