You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4112 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 8 posts

Saturday, March 17th 2007, 2:22am

by SprinklerGuy

Hire out the electrician....please.

Friday, March 16th 2007, 5:34pm

by Wet_Boots

Hire the electrician, and stick with the cheaper timer.

Friday, March 16th 2007, 3:17pm

by jmduke7

The Hunter ICC-800PL does have a 240v inlet (if they have not changed it lately), but, it is for 50 hz not 60 hz (50 hz = international/ 60 hz = domestic), so the answer is no. There is a way you can get the 120v needed off of a 240v line, but, it is not to code and it is unsafe. Your best bet would be to tie into your panel and run a dedicated line to the controller, or better yet, hire an electrician. The cost of an electrician is far less than rebuilding your home or worse yet burying a loved one.

Are there no other 120v circuits or panels in that area that you can tie into? Do you have an exterior socket in the area? If so, there is a panel / weatherproof junction box, that will extend your outlet outward. This will enable you to tie into it and get your 120v and still keep your outlet. Check with your local electrical supply house and see what they have to offer.

Friday, March 16th 2007, 2:38pm


Will the Hunter ICC-800 take the 240 input?

Friday, March 16th 2007, 1:46pm


That explains everything! How can I remedy this problem? I really want use the source available.Can I get a bigger transformer for the controller?

Friday, March 16th 2007, 1:52am

by SprinklerGuy

That should smell good too ;)

Thursday, March 15th 2007, 4:24pm

by jmduke7

Am I to understand you correctly? Is both your well and controller on the same circuit? If this is the case you should test to see if your well is hooked up on a 240 or a 120 volt circuit. If it is hooked up on a 240 volt circuit, you will blow the transformer in the controller. One easy way to tell (if you don't have a multi-meter or an electrician in your immediate friends and family list) is to look at the breaker for your well pump. Does it have a double pole breaker (meaning to levers / switches connected by a bar)?

Thursday, March 15th 2007, 4:11pm


Hunter Pro-C No Power

I Need Help!!! I am installing a hunter Pro-C irrigation controller outdoor model and can not get the unit to power up. I am on the second controller after sending the first back thinking it may have had a bad transformer. When wired up the first time for testing the 2nd controller powered up, but when wires were run and reconnected, no power.I know there is a power supply because I am using the AC power to my well as the power source and when I flip the breaker the well works fine.Any ideas?