You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4166 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Monday, January 22nd 2007, 3:57am

by Wet_Boots

Would you pay a hundred bucks for one? I've repaired systems with those heads, and there are almost always substitutes to be found.

Sunday, January 21st 2007, 7:30am

by fairplay

Your probably right , but it never hurts to keep looking . West Ag sold them under their name for several years , but their distributor group could not find any left in stock anywhere .

Sunday, January 21st 2007, 5:50am

by Wet_Boots

Safe-T-Lawn ball drive rotors fall into the 'almost fiendishly reliable' category, and only lost out because of their manufacturing cost. (and shorter throw, versus gear-drive rotors) ~ The molds and tooling were supposed to have been sold to some private party that will probably never market the heads, once they realize what the market is.

Basically, you will not be able to find them, and the very few remaining are being reserved for spots where a standard head could never fit, even with swing joints.

Saturday, January 20th 2007, 11:26am

by fairplay

Thank you for the suggestion . I already have some swing pipe assemblies made , but I would even buy some old Safe-T-Lawn rotor heads taken out of the ground , if someone is putting in a newer system .

Saturday, January 20th 2007, 8:16am

by Wet_Boots

Use elbows and swing pipe to fit a taller modern rotor head in place of a Safe-T-Lawn ball drive rotor. More work, but no other practical choice exists. Not sure what West Ag rotor you might be talking about, but the same method applies.

Saturday, January 20th 2007, 5:58am

by fairplay

Safe-T-Lawn and West Ag Rotor Heads

Does anyone know where you could buy some of these discontinued heads ? There are no direct replacements made today that are just 4" in height .