You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2707 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, November 21st 2006, 5:11am

by HooKooDooKu

To determine pressure loss, you've just got to look that up in pressure loss charts. But to do even that, you've got to know about how much water should be flowing through the poly. Will it be a single rotor where flows can easily exceed 5GPM, or will it feed a single spray head where flows are likely to be on the order of 1GPM or less?

Here's what I can tell you based on what you've provided so far...
Using 1/2" poly (or 1/2" PVC) you are going to limit your flow to about 5GPM through that 1/2" pipe. If the head(s) at the end of the poly need more than 5GPM, then you will be violating the '7ft/sec speed limit' of the water flow.

At 5GPM, you are going to loose about 1psi for every ten (10) feet (i.e. your 15' of poly would have about 1.5psi loss).

At 1GPM, you are going to loose about 0.5psi for every hundred (100) feet (i.e negligable for lengths of 20' or less).

Monday, November 20th 2006, 8:38am

by silvercvic

well I am going from 3/4" PVC to 15' 1/2" poly to sprinkler head....wanted to know if the head is going to lose a lot of pressure

Monday, November 20th 2006, 7:14am

by drpete3

yes to the second part of your post. the first part is unclear as to what you are asking. You can run poly a long ways waht are you tring to do?

Thursday, November 2nd 2006, 10:56am

by silvercvic

poly pipes question

I was wondering if there is a limit on how long a poly line should be run, rather than dig across 20 ft of grass, is it possible to use poly over PVC?

Also, would it be possible to run PVC -to- poly -to- PVC?