You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4255 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Wednesday, October 25th 2006, 9:07am

by dsknight826

Thank you for your instructions. It turned out to be a very simple solution. The wire connection at the valve came loose. Thanks again !!

Sunday, October 22nd 2006, 10:19am

by mrfixit

Ok this could take a while, so i'm going to skip over a few steps that I do as a repairman, so I don't have to write a book here.
You wont need any special testing equipment this way either.

1. Make sure the wire hasn't come loose from the timer.
2. Turn on station 1 at the timer. Now go out to the valve. It's probably the same color wire that's attached to the timer.
3. Make sure the wires haven't come loose at the valve.
4. Try turning the valve on manually by opening a bleeder screw or by turning the solenoid. If it wont come on then it's the valve itself. Even if it comes on it could still be the valve.
5. With the power on to wire number 1 hook it up to another valve and see if it comes on. If it does the wire's ok and you know it's the valve. If it doesn't come on then the wire's been cut somewhere along the line. Look around, maybe the gardener cut it. There's also a slim possiblity that the timer itself isn't putting out a signal. You could move wire number 2 to the number 1 terminal and turn it on.
The valve should come on.

Basically it's either the timer not putting out power. The wire being cut somewhere between the timer and the valve. The valve itself.

Most valves are easy to repair. Sometimes it's just as easy to change the valve. If you get stuck or need help fixing the valve come on back. Bring the valve name and model number if you can. Or a description will probably do.

Sunday, October 22nd 2006, 7:42am

by dsknight826

I am trying to turn it on manually at the timer.

Saturday, October 21st 2006, 4:47pm

by mrfixit

Hi, do you mean you can't turn it on manually at the timer itself or are you trying to turn it on manually at the valve? I think you mean at the timer but it makes a difference on what I tell you to do.

Saturday, October 21st 2006, 1:56pm

by dsknight826

No Water

I have a Rain Bird ESP-6TM controller which has A and B programs. "A" program controls two stations. The first station will not turn on at all, even manually. What could be the problem? Please help!