You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4448 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Friday, October 13th 2006, 4:49pm

by tviles

Thanks WB you always offer a different approach. I think I will go with what you suggested for the initial test.

Friday, October 13th 2006, 10:20am

by Wet_Boots

It doesn't have to be a foot valve. Combine a 2-inch check with some sort of inlet screen. Myself, I would have the check at the pump, and just screen the intake, unless the vertical suction lift is over, say, ten or fifteen feet.

Friday, October 13th 2006, 7:16am

by tviles

Foot Valve Sizing

Will be running a 2 inch pvc pipe to creek for intake to pump, I will need a foot valve. Question is: I can find 1½ valves no problem, will that work? Pump intake is 2", 1½ hp electric motor. Approx. 30 gpm pump. Do I need to install a tee and put on two 1½ foot valves? Most of my zones are only 2 to 3 rotors per zone. Pump will be 15 to 20 feet from creek side. Thanks, Tracy Spring Hill, KS