You are not logged in.

  • Login
  • Register

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2471 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Thursday, August 17th 2006, 3:00pm

by jmduke7

The common wire is usually the white one connected to the "com" terminal. This is often the source for most wiring problems when all vales or zones are affected.

Thursday, August 17th 2006, 6:35am

by korangu2004

I didn't have to replace the fuse or the transformer. Just removing them and putting them back somehow did the trick (didn't really find out why I had the PR OFF message in the first place). I did remove the transformer out and reconnect the wires.

What is the common wire?

Thanks.

Wednesday, August 16th 2006, 6:13pm

by jmduke7

Check and make sure your common wire is still connected. I am assuming you replaced either a fuse or the transformer on your previous problem. If this is the case you may have accidently disconnected the common wire.

Wednesday, August 16th 2006, 5:56pm

by korangu2004

Rain bird ESP-6TM Controller

I have Rainbird ESP-6TM Controller. I had PR OFF issues to the controller last week but that was resolved and everything started to work.Manual and auto cycles all worked fine

Now, the controller receives power but the Sprinkler heads don't popout with water either in Manual Advance mode or in auto mode. In auto mode, the timer goes to zone 1, the count down begins but the heads don't pop out. Same story in Manual Advance.

Any ideas? Thanks.