You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4366 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, July 7th 2006, 12:44pm

by SprinklerGuy

Pipe in unions necessary if you dig enough.

1 inch valves....primer/teflon tape....

Friday, July 7th 2006, 9:53am

by krl

replacing old valves

I need to replace valves in a 6 zone system. the system is piped with 3/4 PVC pipe and has some sharp 90's right out of the valves. What are best valves and valve sizes to use considering I have 3/4 pipe. Should I use 1 inch vavles and reduce? SHould I go back with all PVC although this may require 6 union fittings or can I switch at vavles to a differnet kind of pipe