You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2978 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Friday, June 2nd 2006, 10:55am

by willcline64

[:)]I investigated the valve to the zone and found some debris in the valve diaphragm. After cleaning the valve no leaks have occurred.

Thanks,

Bill

Tuesday, May 30th 2006, 4:36am

by harleydumonde

I'm pretty inexperienced with sprinklers other than adding sprinkler heads and replacing them. I have a Hunter sprinkler system and over the past 2 years I've had 1 head leaking but it never looked as if the head was the problem. Finally after turning on and off the main water supply valve to prevent the sprinkler head from leaking when not in use, I needed to activate the system and when doing so, I could hear the 1st valve in my 3 zone system attempting to activate but the sprinkler heads in zone 1 would not push out of the ground. If I go to the box where the valves are located and manually adjust a large screw on top of the valve for zone 1, the sprinklers activate and the following 2 zones activate as they should after the programmed time limit is reached.

It is my conclusion with my limited knowledge (dart throw in the dark), that the valve for zone 1 is the cause of my leak mentioned above and needs to be replaced, repaired or adjusted. Can you assist in knowledge here or guide me in any way?

Tuesday, May 9th 2006, 11:58am

by scotteman

I am having the same problem, I believe the zone valve is leaking so I will investigate further to see if I need a new diaphram or can flush the zone any dirt etc. I have have rainbird dvf control valves what are you using?

Friday, May 5th 2006, 4:44am

by willcline64

Leaking Valve?

I have noticed a rotor head in one of my zones that leaks a little bit of water...noticable by a wet spot around that head. After turning on the system this spring, the valve controlling that zone did not close completely, and wet spot around te other two heads in that zone where wet. This was corrected after I manually opened and closed the valve in the ground. However, the one head still seams to leak a little water.

How do I investigate this?? or do I need a new valve?? The system was installed in 2004.

Thanks,

Bill