You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4428 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, May 9th 2006, 10:27pm

by Wet_Boots

Do be aware, however, that there are applications where the Hunter PGP-ATR cannot cannot replace the Maxipaw, because the original will throw water a greater distance with lower water pressure.

Tuesday, May 9th 2006, 5:06pm

by RidgeRun05

Try using a smaller GPM nozzle.

Monday, May 8th 2006, 4:50am

by allwet2


I just replaced two impact sprinkler heads (Rainbird Maxipaw)with two PGP-ATR heads. There are three heads in total on this zone. The third is a rotar head. I have checked the water pressure and it is between 60 and 70 psi. The PGP-ATR heads don't seem to cover the same area as the impact heads. I still have the factory installed nozzels in the heads. I believe they are #7. The sprays seems to be low. Do I need to put in a smaller nozzel to bring up the pressure and just run the heads longer to get the proper amount of water? The rest of the system seems to be running fine. I use town water not a well.