You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3127 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, May 3rd 2006, 2:18pm

by Wet_Boots

As long as the system pressure stays above 30 psi, the PVB will be fine. No additional check valve needed.

Wednesday, May 3rd 2006, 9:26am

by JayG

PVB on a water well - ck valve too?

I have a water well with pressure tank. Well Pump is 16 GPM at 50 psi. Just tied a Febco 765 PVB into the waterline and want to see if I need a spring loaded ck valve between the PVB and the 1.5 inch Sch 40 mainline? Mainline is about 100 ft Property is flat, Hunter I-20 rotors on 1" laterals. PVB is outside and 12 to 18 inches above sprinkler heads. In the country - no gov't restrictions.

Jess on Irrigation tutorials says to use a spring loaded check valve in his section on backflow preventers. This is to reduce spitting at the PVB when well pump runs. In the paid section he advises against PVBs on water well systems.

Will I be OK with a 1" spring loaded PVC check valve after the PVB and then tie in to 1.5" mainline. Any reason to use 1.5" check calve over the 1"?