You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3196 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Wednesday, February 22nd 2006, 2:53am

by Wet_Boots

Six months ago, the offer might have been appreciated.

Tuesday, February 21st 2006, 1:51pm

by Nicholai

i have a ton of solenoids from orbit watermaster 57101's. i modifiy the valves for pneumatic operation which requires me to remove the solenoid and plug the hole for a higher flow hole drilled in the top cover.
All the solenoid does is release pressure on the top of the diaphragm to actuate it, this allows a higher pressure from the bottom to move the diaphragm up and allow the high volume to flow. Since the valve is designed not to leak it actuates slowly. Orbit Watermaster 57101 sprinkler valves are dirt cheap and hold over 130 PSI of air pressure (rougher on the valve than water pressure) since the neoprene diaphragm is tough.

an orbit watermaster 57101 is also a 1" valve so im guessing the threads are probably the same, id give ya one if you needed it, provided that you paid for shipping. I got 35 solenoids sitting on my workbench right now :)

anyways i got a ton of unused solenoids i wouldnt mind getting rid of, im not sure of the thread pattern on them right now but ill post it tomorrow

Tuesday, September 27th 2005, 9:48am

by Wet_Boots

A solenoid from an Irritrol valve should fit, if the old solenoid is a single piece, with 3/4-20 threads (or even a multi-piece with those threads.

Tuesday, September 27th 2005, 8:11am

by LinSquires

Need Solenoid

My system uses 1" Bruckner Valves. One has a shorted solenoid, Bruckner PN 620001, 24V AC, 5.8VA. Does anyone know where I can find a replacement?