You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3289 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Thursday, September 29th 2005, 4:43am

by rand651522

Paul The 2400T is a threaded top.As you look down at it you won't see any screws.Its sometimes called a jartop.You will probably need a large pair of channelocks to unscrew to get to the diaphram.When you get it loose be sure to take carefull note of where the internal spring goes and such, just take your time.I have seen these valves in service and they work just fine I wouldnt worry about changing out the whole thing as any valve can and will go bad eventually.
Hope this helps and best of luck.Randy

Thursday, September 29th 2005, 4:35am

by SprinklerGuy

The entire valve unscrews.....that is a ring around the bod of the valve.....leftie loosie, rightie tightie.

Good luck.

Wednesday, September 28th 2005, 5:06pm

by PaulS

Irritrol 2400T valves

I have Irritrol 2400T valves and one that is stuck open. I've shut off the water supply, replaced the solenoid, and unscrewed the small black ring that the Solenoid screws into on top of the valve, but no luck. I do not see any screws or other hardware that would allow me to take the top of the valve off to check the diaphram. Am I missing something... or do I have to replace the whole valve?

Also, If I have to replace the valve, is there a better model of valve to go with that is more serviceable so I don't run into this problem again in the near future?