You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3269 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Sunday, August 14th 2005, 8:23pm

by RidgeRun05

Still the easiest way to go on SCH 40 PVC is to cut and put in a slip x slip x thread tee for your sprinkler, or slip x thread ell, whichever be the case. The saddle tees and other self tapping methods can be a real headache, and can cause stress fractures which will lead to premature pipe failure.

Sunday, August 14th 2005, 11:21am

by mburnickas

Wet boots is correct here. Sorry about that. I do not even think Kwik Seals would work. Since it is PVC, you would have to do a "t" or something. Then again, I never worked with PVC for sprinlers. Only do PVC from Backflow to valves. Rest is 1" poly for me.

Sunday, August 14th 2005, 10:50am

by Wet_Boots

If the PVC line is schedule 40, you may have some difficulties with the Blazing Saddles - If it is sch 40, would look for something more conventional, even if you have to drill or cut the pipe. Wait and see what others working with sch 40 PVC are using.

Sunday, August 14th 2005, 9:27am

by mburnickas

Blazing saddles are the way to go. Quick and easy...Oh, good movie too! :)

Sunday, July 24th 2005, 6:29pm

by toxin

<font face="Courier New"></font id="Courier New">Blazing saddle tee? Not familiar with that term, you should be able to find a pvc tee that's slipxslipx 1/2" or 3/4' inch thread. If so just get that and screw the funny pipe el into that and run your new head. If not get 1" pvc slipxslipxslip and get a glue in bushing to threads...hope that helps

Saturday, July 23rd 2005, 9:04am

by dewayn

installing another rotor on existing line

I need to install another rotor on existing lateral line which is 1" pvc. I was considering a blazing saddle tee with funny pipe to do the task. Does the blazing saddle tee leave any plastic pieces in the pipe that will need to be flushed out, or is there a better fitting for this install without having to dig up the entire line. thank you!