You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3423 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, July 12th 2005, 2:33pm

by Wet_Boots

http://www.sprinklerwarehouse.com/Custom/tscatlist.asp?PID=226
Backflow protection keeps the water you send into a sprinkler system from flowing backwards and putting your drinking water supply in danger. Lots of old hydraulic sprinkler systems were installed without it, and those systems present a health hazard. http://www.jessstryker.com/sprinkler08.htm

The Toro part number (250-00-04) is for a plastic hydraulic zone valve with one inch threaded ends, and a fitting to take that black plastic hydraulic tubing.

Tuesday, July 12th 2005, 11:41am

by flem3

I live in Texas but we do have lightning. I purchased a controller from a local shop a couple of years ago so I don't have a problem with that. I am trying to find a valve (out of stock most places).

Is backflow protection something that we can add to the existing system (anything special needed for the hydraulic part)?

Sunday, July 10th 2005, 5:37am

by Wet_Boots

Welcome to the 21st century! What you want to do is locate all four valves, and replace them with electric ones. That is where the industry is nowadays. If it happens that the old valves are brass-with-plastic then you might be able to fit a new adapter to the brass part, but for the money, it's cheaper to start over. If you had complete confidence in the (no longer manufactured) hydraulic controller, you could still get Toro hydraulic valves to substitute for the originals. (try Toro part number 250-00-04)

Two caveats. If you are in lightning territory, like Florida, hydraulic controls still have their place. Second, it is likely that there is no backflow protection in that old sprinkler system, and you do want to take care of that oversight.

Sunday, July 10th 2005, 4:28am

by flem3

Moist-O-Matic valve will not shut off

I have an old Toro Moist-O-Matic 4 zone hydraulic system. One of the zones will not shut off (back yard). I have followed the lines from the controller and finally found the first valve (coming off of the main feed from the street) which I believe is for the front yard. If I do find the second and possibly third controller, can I find replacement valves? Am I going about this the right way?