You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3345 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Sunday, June 26th 2005, 8:03am

by Wet_Boots

Just because there have been efficiency improvements in valve solenoids, with the result that entry-level solid-state lawn sprinkler controllers now supply much less power than old motorized controllers did, does not mean that there has been any comparable efficiency improvements in power relays. You are pretty much stuck with having to overspend to supply the power needs of the old relay.

Sunday, June 26th 2005, 3:25am

by water miser

has the system worked before?i would replace it with what the manufacturer of the pump suggest.also on the transformer which plugs into the wall has a va rating which stands for volt/amps.thats the maximum amout of volt/amps the 24v side of the system can have.to determine the volt/amps of the system requires some skill with a meter.if the system has worked before,then all of a sudden not worked ,i would ohm out the relay coil and solinoid coils.
when the controller calls for a zone to be on does the pump turn on?if not is there 220v sitting at the pump?my suggestion is to call someone quilified to systematically troubleshoot the system,and not just change parts.i cann't see blindly changing parts out when it's not needed.you could end up spending more money.

Tuesday, June 14th 2005, 4:08pm

by Wet_Boots

The simplest solution is to buy an expensive controller, like a Hunter ICC, which can supply more current to operate the relay.

Tuesday, June 14th 2005, 10:26am

by 206007075

just took notes this morning.... the pump is 1 1/2 hp, the relay says 30 amp resistive. The controller is a new solid state. Any recommendation to replace the relay.. and if so w/ what? thanks.....

Monday, June 13th 2005, 3:06pm

by Wet_Boots

Old relays might draw too much electricity for modern solid-state controllers. You really need a multimeter to measure the electrical resistance and current draw of the present relay.

Monday, June 13th 2005, 4:07am

by 206007075

Pump Start Relay

Does anyone know what I should replace a 30A pump start relay with? I have a large water pump, 220. The current relay seems to short the zone when it tries to turn on.. Aren't relays fairly reliable? I image this one to be over 10-20 years old.