You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3507 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Friday, May 13th 2005, 5:51pm

by RidgeRun05

You also want to make sure the barb fittings are fully inserted into the poly pipe. Pushing them in only half way may cause them to leak or even come out of the pipe later on down the road.

Wednesday, May 11th 2005, 6:14pm

by Tom

always clamp over the barbs

Wednesday, May 11th 2005, 4:54am

by KEggemeyer

Um, no. I was putting them closer to the end of the poly, after the barbs. Is that what I'm doing wrong?

Tuesday, May 10th 2005, 6:48pm

by Wet_Boots

Is the clamp positioned over the barbs on the poly pipe fitting?

Tuesday, May 10th 2005, 5:24pm

by KEggemeyer

Hose clamps and poly pipe

I'm using PVC for my laterals. To attach the sprinkler heads, I am using PVC female threaded fittings that have plastic barbed fittings screwed into them. I'm using poly pipe for the run from the lateral to the sprinkler. These are clamped down with hose clamps.

My problem is this... I think I'm really tightening the hose clamps, but the water is still leaking out of the fitting (at the poly and barbed end connection). I've looked online and I'm using the same type of fitting sold for poly pipe. So, am I just not tightining the hose clamp enough? Short of breaking the barbed fitting, can you get them too tight?

Kevin