You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4815 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Monday, April 18th 2005, 9:42pm

by RidgeRun05

Could be a problem with your common wire like water miser said, or it could be that all of the backyard zone wires were cut. It is unlikely the problem rests in the controller if the front zones work, or in the valve or valve solenoids, because I doubt it if they would all crap out at once. Have you done any digging or construction recently? I would suggest a qualified contractor come out and run a few electrical tests on your system to see if the problem lies within the wiring.

Monday, April 18th 2005, 5:35pm

by water miser

if you have a seperate valve manifold to feed zones 5-9 in the back chances are the wires been cut or a bad common should call your service co. to properly troubleshoot the system.

Monday, April 18th 2005, 2:31pm

by bilracbost

Not all valves work

We have a 9 valve system controlled by Irritrol RD-900. Zones 1-4, in the front, work fine. Zones 5-9, in the back, won't work when turned on by the controller. They work if turned on manually outside.

Any suggestions?