You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Thursday, July 26th 2018, 6:23am

by Wet_Boots

For your application, the backflow preventer must be an RPZ, and it's just too bad that they cost hundreds of dollars. Save your money and buy some hose-end sprinklers, if you must have watering beyond your allotment. Much more simple and economical.

Wednesday, July 25th 2018, 8:35pm

by RichMoney

I am guessing you want to use the same heads, just add an additional valve that you control?
Essentially what you would be doing is pressurizing the "Zone" side of a valve. When that happens the valve just does not operate, it stays sealed.
So no you will not hurt any control valves, you can T into the zone line anywhere and add another valve.
There might become an issue if one of the 2 valves fail, which may result in finger pointing and a contractor could push the issue with the HOA to possibly hold you liable.
Why not just have the HOA water more frequently?

Wednesday, July 25th 2018, 12:49pm

by artpicone

Two Water Sources Operation for Sprinkler System

My Patio home is irrigated twice weekly by my HOA off of their water header. I have two zones and have located both valves. I want to tap into each zone downstream of the current control valve and add a new valve supplied from my water supply (with appropriate vacuum breaker) and control box. This will allow me to water at additional times. Is this possible or will the back pressure caused when I operate my valves damage the existing control valves and vise versa?