You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, February 6th 2018, 7:16am

by Wet_Boots

If you can program a delay between zones activating, say at least a minute, then you can run an indexing valve with your controller.

Sunday, February 4th 2018, 2:37pm

by MrSteve

Orbit Controler With Indexing Valve

As you may have guessed, I installed an Orbit Water Master #57196 in place of an old pin timer. I see now that I didn't do enough homework as these controllers typically need to control independent valves. I have the old indexing valve and need to know if it's possible to make these compatible. Evidently I need a pause between zones but I'm not sure the controller is capable. I'm trying to save money so the least expensive route? Thank you so much! Steve