You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 475 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Sunday, October 29th 2017, 8:36am

by Wet_Boots

change your plan - stick to conventional tees and ells

Sunday, October 29th 2017, 1:35am

by dgileadi (Guest)

60 Degree Bend

Hi, newbie here. I’ve been reading what I can about designing my sprinkler system, and I hear that a triangular pattern is preferred for good coverage. That works for me, but when it comes to planning the pipe layout I’m a bit baffled. There are a couple spots where it makes the most sense to follow the 60 degree bend of one corner of a triangle to supply the next head. However, I’m not aware of a 60 degree elbow for 1” or 3/4” PVC. Should I be attempting to follow the 60 bend in my plan, and if so what kind of part should I use?