You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 412 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, October 31st 2017, 1:29pm

by Wet_Boots

Are there any primary-connection options? Some lighting transformers might have a split-wired primary to accommodate input voltages slightly higher or lower than norm.

All said and done, upgrading your output wiring is the simplest approach.

Thursday, October 26th 2017, 4:09pm

by BackflowInspector

A lot of this depends on your cable gauge.
A thicker cable will allow you more flexiblity.

It may also make sense to understand if you are using LED or Halogen.

You may want to use LED to help with your situation.

In my experience it is critical to follow the transformer specs to avoid tripping the transformer. :)

Wednesday, October 25th 2017, 7:31pm

by raygo

Low Voltage Lighting Question

I have a very long run and would like help optimizing. I have two 300W transformers in one 600W unit.
I have a 290' run, 325' run and a 250' run. I can connect the 290 and 325 into a loop if I add 35' to create one big 650' run (apparently it only counts as half run for calculations). I only have light loads. 66W on the 290' run. 66W on the 325' run. 77W on the 250' run.

Can someone figure out my optimal layout? Options include
- combine 290 and 325 runs into a loop?
- combine 250' and 290' runs into a V?
All my options exceed the recommended allowances. I don't know how critical it is to abide by these?
My voltage drop on the combined 650' run with only 130W is likely too high according to the formula.

Thank you in advance to any genius who can help me.