You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3767 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, March 30th 2004, 12:23pm

by jenksb

Thanks Aquamatic...the torch worked great!! no leaks!!! Thanks again.

Tuesday, March 30th 2004, 6:21am

by aquamatic

General rule is no!
But most contractors do- You need to just float the pipe about 2" away from the flame for about 3 seconds and thats it, just enough to provide a little warmth to the pipe. If you notice it turning glossy and melty, cut the tip and start over.

You can also lube with dish soap or KY jelly- this wont harm the plastics

Tuesday, March 30th 2004, 5:29am

by jenksb

Connecting fittings to poly

I have a question, I was told to use a hair dryer to soften the poly when putting fittings on as this helps mold the pieces together to cut down on leaks. Here's my question, can I apply heat carefully to the poly with my propane torch? Please any advice?