You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 573 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Saturday, August 26th 2017, 3:07pm

by mrfixit

I'd start off by taking the bonnet off of the valve and inspecting the diaphragm. The older 205's diaphragm had a white plastic screw instead of the stainless they use today. That plastic breaks in half and the valve wont come on all the way. If that's the case, make sure you get that broke off piece out of the manifold or it could cause one of the valves to get stuck on.

If the valve's working correctly then look for a break in the line. Look at the spray out of the heads, can you see where there's a big drop in pressure from one to the next? Look there for water.

I don't know if you have poly pipes or not. They can get pinched from tree roots.

Saturday, August 26th 2017, 9:05am

by Thew60

Low flow through entire zone

Good morning. I am new to this forum and I'm looking for some advice. I have an older 4 zone system controlled with Richdel 205 valves and a MOODY controller. I do much of the maintenance myself including replacing heads and fixing the line breaks. I do have it professionally blown out and started up though. I have four zones and I have low flow through ALL of the zone three. Opening the bleeder valve on that zone still shows low flow. When I feel the supply pipe that is above ground the flow through that pipe feels normal even when I open the bleeder. To me that suggests that there was a problem in the line not in the valve. I'm looking for some suggestions on troubleshooting as this may be a little bit beyond my knowledge base. Thanks!!