You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 561 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Monday, May 29th 2017, 8:26pm

by mrfixit

I use two pair of large channellocks.

Monday, May 29th 2017, 3:04pm

by tpawlak

Appreciate the help!!!! I like the idea of replacing the insides. I just tried a couple of them and one of the tops unscrewed but the other tops are on very tight and the body started to unscrew so I stopped. Any advice on how to loosen the top so I don't have to take the body out as if I replace the units without digging won't I have to worry about dirt getting inside the pipe?

Monday, May 29th 2017, 12:58pm

by mrfixit

No worries, they're the same height. If there's any difference it would be about 1/32 of an inch because of the rubber seal
If you don't have problems with low head drainage you don't need a check valve.
With the sprinklers in question you might be able to just unscrew them without digging. But with swing joints or marlex ells you need to be careful they don't turn on you while trying to install the new head. You can ruin the threads.
Or you could simply unscrew the innards leaving the body in the ground and replacing all the working parts.
Or just dig them up and replace the whole thing. Your call. Unscrewing them without digging can save a lot of time and effort.

Monday, May 29th 2017, 10:14am

by tpawlak

Help needed on replacing Hunter PGP Ultra Rotors

I need to replace several of the Hunter PGP Ultra Rotors on my sprinkler system that is approximately 7 years old. I went to the Sprinkler Warehouse and I am confused by about the check valve option to so could use I some help. The Rotors I am replacing have Black Caps with "Hunter PGP Ultra" on them but I do not know if they have a check valve installed. My yard is pretty flat but I do not know how to tell the difference. Is it OK to mix PGP Ultras with PGP Ultras w/ check valve and if so which should I order. Also is there a height difference. Not sure it matters as they are all on swing so a little height difference should matter but thought I better ask than
assume it doesn’t matter.
Any help would b e appreciated!