You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 488 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, May 23rd 2017, 2:14pm

by mrfixit

Yep it sounds like there's a short on valve 1. There's a good chance it's the solenoid. You could remove the wire from the number 1 valve at the solenoid, then start the controller. Does it still short out? If no then the solenoid's bad. If it still shorts out then the wire from the timer to the valve is shorting out. Is there a spare wire you can use? Are there bare wires anywhere touching?

Monday, May 22nd 2017, 7:47pm

by welbus

Hunter SRC pump relay question

I have a Hunter SRC with a hunter pump start relay that had worked fine until the other day when it stopped working. The SRC controller seemed to be working fine, but would not cycle the relay to start the pump. After jumpering I determined that the relay was fine, but was still at a loss. In frustration I started the controller in "manual all stations" mode, and just let it run through its cycle even though the pump was not running, and there was no water. Later, after doing so I noticed that it had blown the fuse. I replace the fuse, and gave it another go, just to experience the same frustration. However in doing a little more tinkering, I noticed that it would start the pump and work fine if I started it on station 2. So, is this Hunter self protecting and avoiding starting on station 1 because there is no load and detecting that the solenoid valve is bad? Any other ideas?