You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 641 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Monday, May 22nd 2017, 7:54pm

by mrfixit

I had to uninstall one of these today. It wasn't turning anymore but it too was leaking where yours was. I went to unscrew it and the dang the wouldn't budge. I finally got it and I can see why you though there might be an o-ring inside there. Nope there's no o-ring or rubber seal. Just tape her up.

Saturday, May 20th 2017, 5:09pm

by mrfixit

I haven't dealt with one of those in years. Is there supposed to be a gasket in there? hmm Not an O-ring that I'm certain.
You can put teflon tape around the threads and tighten it up good.

Saturday, May 20th 2017, 9:07am

by hallcg (Guest)

hunter PGP sprinkler head

I have a leaking Hunter PGP sprinkler head. It is a raised (non-pop up) unit in a garden and it leaks around the screw-on cap. The plastic seems intact. I see no cracks in the plastic. Everything is tight. Is there supposed to be an o-ring under the cap, because I don't see one under this cap? Thanks.