You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, May 1st 2017, 2:26pm

by WanderingNunican

Larger pipes mean less friction loss due to lower velocity. I would probably downsize from the mainline to the laterals, but I don't think you would need to if you have the larger pipe just laying around. Connecting the heads to 2" pipe might be an adventure....
FYI, I'm no expert I just have some knowledge of fluid dynamics :)

Tuesday, April 18th 2017, 11:12am

by jeff1

Correct pipe and pump size

I have a 2hp pump with a 2" intake and 1.5" outflow. I have approx. 2,000 feet of 2" pipe laying around and would like to use it for my sprinkler project. If I were to run 2" line from the 1.5" outflow of the pump as the main water line until I need to downsize the pipe near the rotary heads, would the pressure be effected ? I would be pumping 1.5 into a 2" and then stepping it down to 1.25 and 1" line. Any thoughts?