You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 375 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, October 11th 2016, 6:41am

by illinoisjim

They said remove the old one with channel lock pliers (damages it but normally don't remove unless replacing anyway) and put the new one in hand tight. Took quite a bit of work to get the threads cleaned up enough to get the new one in...

Monday, October 10th 2016, 9:59am

by Wet_Boots

call A.Y. McDonald at 1-800-2-nine-2-2-seven-37

Monday, October 10th 2016, 6:15am

by illinoisjim

Replacing jet help

Putting a high pressure jet in a 8500 series AYMcDonald pump. Couldn't get the old one out without breaking it (plastic) which, from what I have read, isn't that unusual. Now need to put in the new one. Housing is cast iron so will clean out the threads with a wire brush, etc. My biggest question is how to get it in tight. There are 2 small keys on the sides of the body but they are so far down and with it in the pump body it is nearly impossible to get anything on them and I am worried I am going to mess up the new one. Is there some special wrench?

Should I put something for lube on the threads to make it go in easier/come out easier?