You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 5246 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Sunday, February 8th 2004, 10:37am

by Rendaug

SprinklerGuy comes through again.... I had been traveling and not able to try your recommendation, but it worked - solenoid was bad, did not trip when disconnected. Changed out and boom water again, thanks.

Tuesday, January 20th 2004, 2:28am

by SprinklerGuy

If it is popping the reset button..more than likely a bad solenoid on zone 3.....or direct short.

Locate zone 3....remove wires from solenoid....try again with timer. With the solenoid essentially now removed from the shouldn't pop the reset button. If it does, it isn't the solenoid, if it doesn't...replace the solenoid, should work.

Good luck,

Monday, January 19th 2004, 3:54am

by drpete3

did this just start or is this a new installation?

Sunday, January 18th 2004, 12:31pm

by Rendaug

Clueless where to start

I have an imperial 6 zone controller that will not run zone 3. It continues to pop the reset button on the control panel. I can manually run zones 1,2,4 and nothing is connected to 5,6. Any thoughts would be appreciated.