You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1217 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Saturday, July 18th 2015, 10:00am

by Wet_Boots

If nowhere in the supply chain is a valve that will shut off a hundred percent, you definitely need to have one installed. Is there a shutoff valve upstream and downstream of the water meter?

Saturday, July 18th 2015, 12:28am

by mtrumpetg

Well, I guess I should. I also measured the water pressure, and it's coming in at 102psi! Guess my next call is to the city water folks. I've never even looked at the back flow valve in 20 years. So much for trying to save money by doing it myself. thanks for your help.

Friday, July 17th 2015, 11:35pm

by mrfixit

Maybe you should install a shut off valve that works.

Friday, July 17th 2015, 10:05pm

by mtrumpetg

Backflow valve

The back flow valve won't budge and turning water off at the meter doesn't work either. I will have to go ahead and use a couple of push-on connectors to make the repair.

Friday, July 17th 2015, 6:38pm

by mrfixit

Did you turn off the valve at the water meter?

You should try again to turn the valve off at the backflow. Use a pair of channel locks. Those can be hard to turn sometimes but it should turn.

Sometimes the water will continue to squirt out of a crack for a while even with the water supply shut off. You could try releasing the pressure from a hose bib somewhere in the yard. Maybe there's a second manifold where you can open a valve to release the pressure. Or just turn on one of the valves at the cracked manifold to drain the water as much as you can.
Look for a downstream faucet to divert the water to.

An old plumbers trick is to use some squishy white bread to seal the pipe then do the repair quickly. After you're done with the repair blow out the bread. You might want to disassemble the last valve on that manifold or cut it off then flush out the bread.

There's also a product called wet n dry glue. It will help a lot if there's water present. I personally try to avoid relying on wet n dry but I've been known to use it.

When you turn the water back on make sure to get all the air out of the line by turning on valves and faucets.

Friday, July 17th 2015, 5:38pm

by mtrumpetg

Can't shut off water

I have a joint leaking below a valve - underground. I managed to dig out enough space to replace the leaking joint, but I am not able to shut off the water. I've tried the irrigation valve shut off as well as the whole house water supply, but the leak is still spraying water. I tried the back flow valve but can't get it to move (and it's in a hard to reach location). In the past when I've changed sprinkler valves, there has always been a slow stream of water out of the line, making it difficult to glue pvc.

Any ideas?