You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3807 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 10 posts

Saturday, November 15th 2003, 12:49pm

by Rays Sprinklers

[:-)]

Saturday, November 15th 2003, 10:28am

by DIYer


See: http://jerman.com/backflowpreventers/FEBCO/ssfp765.pdf

Friday, October 31st 2003, 12:17pm

by Rays Sprinklers

[:D]

Friday, October 31st 2003, 7:19am

by Murphy

I used AVPBs and I just remove them every winter and store them in the garage. I use unions so they are easy to remove. Then, just blow out using a T or use the threads the union is screwed to.

Wednesday, October 29th 2003, 2:10pm

by Joseph L. Swinehart

Excatly right, no more than 45 psi, and we did blow through the backflows, Colorado winters.


Watch the closest head to you, watch all the water come out and go to the next zone.

Good luck.

Joe S.

Thursday, October 9th 2003, 4:31pm

by Rays Sprinklers

Yea....anything really over 80 your messin with...some guys have huge trailored compressors, which allows for them to winterize the entire system at once and under 3 minutes...ive seen this done...its pretty neat....its ok to winterize through backflow......like bhungue said water flows through..and if they are outside you have to get the water out

Thursday, October 9th 2003, 7:01am

by bhungue2

[:D]

Wednesday, October 8th 2003, 3:19pm

by RVLI

Your not supposed to blow out sprinkler systems with high pressure. Use a 45 psi regulated high cfm air compressor, such as the pull behind type used to jackhammers and stuff, but regulated to about 45-50 psi.

Wednesday, October 8th 2003, 2:49pm

by bhungue2

We install our blow plugs before the doublecheck. I have heard that you're not supposed to blow through them. But I can't figure out why blowing air through would do any more damage than letting water flow through. We've never experienced any problems with doing it this way.

Wednesday, October 8th 2003, 2:38pm

by aquamatic

Winterizing Before Backflow

I have hear a few different opinions on this one--

Is it OK to winterize with pressurized air before the backflow verses after. I have a few setups that have the drain plug before and some after.

Will the high pressure damage the PVB???