You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 5437 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Friday, August 1st 2003, 10:07am

by Rays Sprinklers

WHere did you purchase the Hunter SRC.......? NOrmally if the controller is broken and you explain this happened because of lightning then the dealer is not allowed to take the controller back even if it is in should replace the fuse with the one that the controller came with...... The ball valve to shut off the irrigation system is located where the water is connected to the main supply line. If the valves are leaking it is possible that there is a possbile crack in the pipe. Di you have the system properly winterized?? Let us know what you find?

Rays Above and Beyond Automatic Lawn Sprinklers

Friday, August 1st 2003, 7:30am

by Grub

Thanks a bunch. I'll check


Thursday, July 31st 2003, 3:14pm

by Warren

I do not have the inside details on how the Hunter controller works, but most systems are very much the same.

The timer functions and settings are managed by an embeded controller. This controller is typically run using low voltage logic levels like 5 volts DC or 12 volts DC. They are also isolated from the valves using independent high current transistors.

Based on your information, either the high current transistors took the hit from the lightning and fused two zones together, or out underground somewhere two valve wires were fused together by the high current generated by the lightining strike.

The easy way to figure this out is to remove one of the wires from one of the two joined valves right at the controller and run the system.

If the second valve still comes on, then the wires are fused somewhere down the line. If the disconnected valve does not come on, then the short is most likley in the high current transistor module. Some of these are replaceable and some are not. I would check with Hunter.


Thursday, July 31st 2003, 2:54pm

by Grub

Hunter src controller hit by lightning

I went to my garage during a storm and a loud thunder clap scared me back inside. I later found the fuse blown in my Hunder SRC 9 zone controller. I put a new fuse in (first trying a 1 amp 250 v instead of the .75 a 125 v, then found a .75 a 250 v at radio shack). Same problem with either fuse. Zone 1 and 2 come on together and stay on. When I try to run one zone (zone 5) it comes on with the other 2 still on then shuts down.

Do I need a new controller or can it be fixed. It seems to operate fine otherwise as far as setting schedules, dates, times, and zones.

Question 2. I have 2 plastic green plates on the side of my yard covering something (valves?). One of these is seeping water constantly even when the system is off. Where would the shutoff valve for the irrigation system be normally? and how can I repair this leaking thing (Valve?).

thanks in advance